Klarfit Ultimate Gym 9000 Mode D'emploi page 39

EN
5
Note: Oil Bushing (65) have been Pre-assembled into Upper Cross Beam (18).
Attach the Press Bar (13) to the Upper Cross Beam (18), using one M12X150mm Hex Bolt (96), two M12 Washers (110) and one M12 Nylon Nuts
(116).
Attach the Left & Right Butterfly Arm (11&12) to the Press Bar (13), using two M10X85mm Hex Bolts (98), four M10 Washers (112) and two M10
Nylon Nuts (117).
Slide two Arm Foam Rollers (52) onto the Left & Right Butterfly Arm (11&12).
Remove two M10X20mm Hex Bolts (104) and two M10 Washers (112) from two Handle Tubes (15).
Attach two Handle Tubes (15) to the Left & Right Butterfly Arm (11&12), using two M10X20mm Hex Bolts (104) and two M10 Washers (112).
Slide two Mid-empty Square Plugs (80) and two Handle Grips (77) onto the Left & Right Butterfly Arm (11&12).
Attach the Tobacco-pipe (44) to the Resist Bar (7), using one M8X40mm Hex Bolt (107), two M8 Washers (114) and one M8 Nylon Nut (118).
Slide the Washer (111) and the Plum Blossom Nut (61) onto the Tobacco-pipe (44).
39