Publicité
Les langues disponibles
Les langues disponibles
STEP 2 – ADJUST LEVELING LEGS
•Move the dishwasher close to the installation
location and lay it on its back.
Adjust to
Adjust to
Installation
Installation
Height
Height
Figure 8
•Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4"less than installation height.
STEP 3 – REMOVE TOEKICK
•Remove the 2 toekick screws. Lift off the 2 piece
toekick.
Figure 9
Installation Instruction
2-Screws
STEP 4 – INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422and/or local
codes and ordinances.
Recommended power cord length is 54" min. and 64" max.
A
Remove
Junction Box
Cover
D
Use UL Listed
Wire Nuts
Figure 10
Connect incoming
power cord white (or ribbed)
to dishwasher white. Black
(or smooth) to black. Ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
Replace junction box cover . Be sure wires are not
pinched under the cover .
STEP 5 – INSTALL 90° ELBOW
Wrap 90 elbow with thread seal tape.
Install a 90 elbow onto the water valve.
90
Elbow
Figure 11
•Do not over Tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
•Position the end of the elbow to face the rear of the
dishwasher .
6
B
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
White
Ground
C
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Fill
Hose
Water
Valve
Bracket
Thread
Seal Tape
Black
Publicité
