Troubleshooting; Disposal; Technical Specifications; 4000 Programmable Channels - Samsung DSR 9401 FTA Consignes D'utilisation

TROUBLESHOOTING

Problem Possible cause
No display LED on Power cord
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode;
Scart not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound Audio cord connected
incorrectly;
Loudness level = 0;
Muting active
Remote Control does not incorrect operation;
operate directly
Batteries dead or inserted
incorrectly
Poor picture quality Signal strength too low
On-Screen Error Message Antenna cable not connected
"Searching for signal" or not tight;
LNB defective;
incorrect position of the
satellite antenna;
On-Screen Error Message Satellite not yet set
"Channel data
does not exist."
On-Screen Error Messages: Smartcard:
"Please check the - not plugged in correctly;
Smartcard"; - not plugged in.
"Please insert the
Smartcard".

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries
must never be disposed of with household refuse.
Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate
locations provided.
Solution of the problem
Power cord plug in correctly
Back switch in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control
towards the Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Auto Scan" menu, correct alignment
of your antenna
Check connection and correct;
Change LNB;
Check position and correct,
Check the signal strength in
the "Auto Scan" menu
Scan of in "Automatic scanning"
or "Manual scanning" menu
(depend on model)
Check the Smartcard.
"Insert the Smartcard."
GB-30
D I G I T A L S

TECHNICAL SPECIFICATIONS

1. User section

4000 programmable channels,

software download via satellite & PC,

advanced Electronic Program Guide,

multi-language supported for OSD,
DiSEqC 1.2 supported full function
infrared remote control unit,
2. Tuner section
950 ~ 2150 MHz wide band tuner,
supporting DiSEqC 1.2 version,
3. Video section
DVB-S compliant,
MPEG-2 video (MP@ML)
2 - 45 Ms/s symbol rate
4. Audio section
MPEG 1 audio layer I & II
mono, dual, stereo and joint stereo audio
mode,
Power supply
Type:
Input Voltage:
Power Consumption:
Stand by:
VIDEO DECODER
Transport
Transport stream
Input Rate
YUV format
Aspect ratio
Resolution
Scale
A T E L L I T E R E C E I

auto and manual scan facility,

channel organizing (programmable),

SCARTS output,

low power consumption

13 V/18 V switching,
22 kHz continuous tone control

compatible for both SCPC/MCPC,

supports aspect ratio 4:3 (normal) and
16:9 (wide screen)
32, 44.1 and 48 kHz sampling
frequencies,

volume control and mute function through

Remote Control Unit.

SMPS
100-240V AC 50/60Hz
Max. 25W
11W
MPEG-2 ISO/IEC 13818
Transport stream Specification
MPEG-2 MP@ML
Up to 100Mbps
4:2:2
4:3, 16:9
720 x 576, 704 x 576,
544 x 576, 480 x 576,
352 x 576, 352 x 288
0.5, 2.0 in both horizontal and vertical
directions
GB-31
V E R