Connecting Your Stb - Samsung DSR 9401 FTA Consignes D'utilisation

CONNECTING YOUR "STB"
1. LOCATION OF THE RECEIVER
Your STB should be placed under proper ventilation.
Don't put in completely enclosed cabinet that will restrict the flow of air,
resulting in overheating.
The location should be safeguarded from direct sunlight,
excess moisture, rough handling or household pets.
Avoid stacking other electronic components on the top of the receiver.
The location should be safely accessible by the cable from your
antenna system.
2. CONNECTING THE RECEIVER WITH DISH SYSTEM
After installing your antenna system, connect the coaxial cable from the
LNB of your antenna to "LNB" terminal marked at the rear
of the STB.
All cable connectors should be finger tightened; do not use any kind
of wrench while tightenning connectors. The cable should be 75ohm
impedance coaxial twisted at the end with an "F" type connector.
3. CONNECTING THE RECEIVER TO TV
To connect the receiver with your television, you can use Scart Cable.
In the case of connecting your TV through SCART cable, connect the
SCART connector marked TV to the respective SCART port on the TV.
4. CONNECTING YOUR VCR
To connect a VCR, the STB has been provided with SCART at the rear
marked "VCR".
Using a SCART connector, the VCR can be connected to the receiver.
N N o o t t e e : This is supported by standby.
5. CONNECTING YOUR DIGITAL AUDIO SYSTEM
If you have a DAC with S/PDIF optical cable input, you can connect the STB
with it to enjoy higher quality sound. Connect S/PDIF optical cable to a digital
amplifier.
6. INSERTING SMARTCARDS FOR VIACCESS SERVICES
(For model DSB-9401V)
In order to view a scrambled service, you need to have a valid Smartcard.
This DSB-9401V has the Viaccess CAS embedded to view Viaccess programmes.
N N o o t t e e : Insert the Smartcard with the gold coloured chip facing downwards.
GB-4
D I G I T A L S
Connecting Figure
A T E L L I T E R E C E I
CONNECTING YOUR "STB"
GB-5
V E R