Quick Start; Power On; Zero - Baxtran STA Manuel D'usager

STA/STR/STC
This Quick Start introduction will guide you through these basic operations on the crane scale. To make
full use of this versatile scale, please refer to 5 Advanced Operation section.

POWER ON

ACTION
To power on the scale, press
FUNCTION
Scale goes through power-on test, battery check and initialization.
CONDITION
Power-on test is performed when display flashes the following characters twice. If scale doesn't pass
the test, error message will be flashed
Scale's maximum capacity will be displayed on the screen. For example, the scale shows its full capa-
city, 5000kg.
Battery Check is then performed. If battery works well, the screen flashes battery charge twice.
Please flip to 7 Battery section for more information about battery recharging.
WARNING:
Scale must work at the battery voltage ranging from 6.80V to 5.80V. Recharge the battery
when needed.
Finally, the screen shows detection message while scale detects its load and
status, when the
To learn more about Auto-Zero function, refer to Auto-Zero Range in Scale Configuration function
for details.
After scale is completely powered up, it is ready to weigh loads.

ZERO

ACTION
To ZERO the scale, press
FUNCTION
Scale sets current load to be ZERO, as if it has no load.
The ZERO indicator lights on.
The weight reading turns "0", (or "0.0" or "0.00", depending on the resolution).
ON/OFF button on scale for 1 second.
AUTO-ZERO function is enabled.
ZERO button on scale or

4. QUICK START

AUTO-ZERO
on remote controller.
User's Guide
itself to ZERO
37