Fireplace Installation; Site Selection - Dimplex CEL50 Manuel Du Propriétaire

Fireplace Installation

Site Selection

Review and consider all of the
following conditions for installation:
• Dimensions of the unit: 50
(128cm) x 19½" (49.5cm)
• Unit requires a minimum of two
wall studs in order to ensure a
secure installation
Three possible installation
methods:
• Surface mount (pg. 12); In-wall
Recessed (pg. 13); or Flush
mount (pg. 15)
• Hardwired or plug-in method
CAUTION: Ensure installation
does not allow fireplace to be in
direct contact with building vapor
barrier or insulation and meets all
local building code.
!
NOTE 1: A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A dedicated
circuit will be required if, after
installation, the circuit breaker
trips or fuse blows on a regular
basis when the heater is
operating. Additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
WARNING: Ensure the power
cord is not installed so that it is
8
pinched or against a sharp edge
and ensure that the power cord
is stored or secured to avoid
tripping or snagging to reduce
/ "
5
16
the risk of fire, electric shock or
injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the
risk of fire, do not store or use
gasoline or other flammable
vapors or liquids in the vicinity of
the heater.
1. Select a location that is not
susceptible to moisture and
is away from drapes, furniture
and high traffic.
2. For ease of electrical hook up
you may wish to locate the
fireplace near an existing outlet
(for plug-in convenience) (refer
to NOTE 1).
3. Remove fireplace, front glass
and hardware from box and
remove all packaging materials
before installation.
4. Store the fireplace in a safe,
dry and dust free location until
you are ready to install the
fireplace.
www.dimplex.com