Incorrect Operation - Columbus McKinnon TIGRIP TTS 1,0/1000 E Traduction De Mode D'emploi

18
The spreader beam must only be used in the area close to the ground.
Do not allow personnel to stay or pass under a suspended load.
A lifted or clamped load must not be left unattended or remain lifted or clamped for a longer
period of time.
The operator may start moving the load only after it has been attached correctly and all
persons are clear of the danger zone.
When suspending the load lifting attachment, the operator must ensure that neither the load
lifting attachment, the suspension (e.g. hook, shackle, etc.) nor the load pose a danger to
himself or other personnel.
Prior to operation of the load lifting attachment in special atmospheres (high humidity, salty,
caustic, alkaline) or handling hazardous goods (e.g. molten compounds, radioactive materials)
consult the manufacturer for advice.
The load lifting attachment may be used at ambient temperatures between –40° C and
+100° C. Consult the manufacturer in the case of extreme working conditions.
Always transport the load slowly, carefully and close to the ground.
For lifting and lowering, make sure the load is in a stable position in order to avoid accidents
due to tipping, rolling or falling. This also applies to loads stored on the side or underneath.
The operator should always stand next to the load lifting attachment at a safety distance of
one arm's length.
When spreader beams are not used, set them up in a stable position. Use support stands for
this purpose, as required.
Only use crane hooks with a safety latch.
The suspension eye of the load lifting attachment must have sufficient space in the crane hook
and be freely articulating.
In the case of malfunctions, stop using the load lifting attachment immediately.
I O
NCORRECT PERATION
(list not complete)
Do not exceed the rated load capacity (WLL) of the unit. Together with the deadweight of the
spreader beam (Tab. 1 and 2) incl. all means of attachment, the weight of the load must not
exceed the load capacity of the crane used.
Any modifications of the load lifting attachment are prohibited.
It is forbidden to use the load lifting attachment for the transportation of persons.
When transporting loads ensure that the load does not swing or come into contact with other
objects.
Transporting more than one load or a load, which may shift, loosen or fall during the transport
process, is not permissible.
It is forbidden to attach loads to existing binding wires or retaining strips and lift them!
It is forbidden to apply lateral tensile forces to the load lifting attachment.
The hook safety latches on the ends of the spreader beam must always be closed when
ropes, lifting belts or chains are attached.
©
2016 Columbus McKinnon Industrial Products GmbH