Introduction; Correct Operation - Columbus McKinnon TIGRIP TTS 1,0/1000 E Traduction De Mode D'emploi

15
I
NTRODUCTION
Products of CMCO Industrial Products GmbH have been built in accordance with the state-of-
the-art and generally accepted engineering standards. Nonetheless, incorrect handling when
using the products may cause dangers to life and limb of the user or third parties and/or
damage to the hoist or other property.
The operating personnel must have been instructed before starting work. For this purpose, all
operators must read these operating instructions carefully prior to the initial operation.
These operating instructions are intended to acquaint the user with the product and enable
him to use it to the full extent of its intended capabilities. The operating instructions contain
important information on how to operate the product in a safe, correct and economic way.
Acting in accordance with these instructions helps to avoid dangers, reduce repair costs and
downtimes and to increase the reliability and lifetime of the product. The instructions must
always be available at the place where the product is operated. Apart from the operating
instructions and the accident prevention act valid for the respective country and area where
the product is used, the commonly accepted regulations for safe and professional work must
also be adhered to.
The personnel responsible for operation, maintenance or repair of the product must read,
understand and follow these operating instructions.
The indicated protective measures will only provide the necessary safety, if the product is
operated correctly and installed and/or maintained according to the instructions. The operating
company is committed to ensure safe and trouble-free operation of the product.
C O
ORRECT PERATION
The load lifting attachment is used for safely transporting long, bulky and heavy loads which
for reasons of a better weight distribution or reduction of deflection must be attached at
several points.
● The standard spreader beam is only suitable for transporting loads which can be attached in
such a way that their centre of gravity is directly below the suspension eye in perpendicular
direction. The standard spreader beam cannot be adapted to different lengths of the loads. If
the centre of gravity is not below the suspension eye, an impermissible inclination of the
spreader beam results.
©
2016 Columbus McKinnon Industrial Products GmbH