Installation; Operation - Klarstein Alpbach Mode D'emploi

EN
26
Preparing the remote control and replacing the battery
When using the unit for the first time,
the plastic cover must be removed from
the battery compartment of the remote
control.

INSTALLATION

1. Make sure that the power plug is removed from the socket before installation.
2. After installation, plug the power plug into the power outlet. If the power cord is
not long enough, an extension cord can be used. The power of the extension cord
should be at least 2000 W.

OPERATION

Activate device
Open the cover and move the power switch to the „I" position. The device is now in
standby mode.
Switching on/off
Press the ON/OFF button to switch the appliance on/off and activate/deactivate the
flame effect. The screen will display the following on the first power-up:
If the remote control battery runs out,
replace it with a battery of the same type
(CR2025 3V).
Plastic cover
Battery