Miele STB 20 Turbo XS Mode D'emploi page 10

en
Illustrations
The illustrations referred to in the text
are shown at the end of these operat-
ing instructions.
Turbobrush features
The Turbobrush is operated by the suc-
tion power of the vacuum cleaner. It has
a rotating roller brush which is very ef-
fective at vacuuming up thread, hair
and fluff.
Use
Recommended use (dia. 01)
When using the Turbobrush please
also observe the warning and safety
instructions in your vacuum cleaner
instruction manual.
This Turbobrush is particularly suitable
for vacuuming upholstery, mattresses,
car seats and carpeted stairs.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
Fitting the Turbobrush
 Connect the Turbobrush to the
handle or suction tube on your va-
cuum cleaner depending on how you
wish to use it.
Using the Turbobrush (dia. 02)
 To achieve the best effect, use a me-
dium suction power setting and pass
the Turbobrush slowly backwards
and forwards over the surface being
vacuumed.
10
If a medium suction power setting is
not strong enough select a higher set-
ting.
The rotating head enables the optimum
angle to be set. Ribs on the side of the
Turbobrush can be used to dislodge
stubborn soiling.
Maintenance and care of the
Turbobrush
Always disconnect the vacuum

cleaner from the electrical supply for
cleaning and maintenance work on
the Turbobrush. Switch off at the wall
socket and unplug it.
Removing threads and hairs
(dia. 03 + 04)
 Use scissors to cut any threads or
hairs which have wound around the
roller brush. There is a groove on the
roller to guide you (dia. 03).
Then run the vacuum cleaner to va-
cuum up the bits.
For more obstinate tangles or block-
ages inside the Turbobrush, the cover
can be opened. Any large particles can
then be easily removed.
 Press the release button and remove
the cover (dia. 04).
 Remove any dirt in the brush com-
partment interior and from the roller
brush.
 Replace the cover.