Insert The Batteries; Charge Battery Pack - Carson The Beast Consignes De Sécurité

INSERT THE BATTERIES

1. On the underside of the model, open the battery compartment
latches (4).
2. Connect the fully charged battery on the intended plug in the
battery compartment. Pay attention to the correct polarity.
3. Fix and re-close battery compartment.

CHARGE BATTERY PACK

Only charge the battery pack using the charger supplied.
Charging procedure:
1. Connect the charge to a normal USB connection (e.g.
computer). STATUS LED IS PERMANENTLY ON.
2. Connect the battery using the provided plug. STATUS LED
FLASHES.
3. Batteries are fully charged STATUS LED GOES OFF (charging
time approx. 4-5 hours).
Charging instructions: Attention!!!!
Important information about your rechargeable 7.2V NiMH Battery
pack. (See drawing)
1. Let the charger and the battery during charging never unatten-
ded.
2. If the speed / performance of your RC model decreases or even
stops, immediately stop operation and charge the battery (Note
the charge time: point 1) again.
3. To maintain the performance of the battery, please charge the
battery only when it is empty.
GB // 14