Installing The Transmitter Batteries; Turn On The Rc System; Binding - Carson Beetle Warrior 2WD 2.4G Mode D'emploi

INSTALLING THE TRANSMITTER BATTERIES

TURN ON THE RC SYSTEM

CAUTION!
Always turn the transmit-
ter´s power switch ON first!
Please change batteries when LED
status flashes on transmitter!!!
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.
2
ON OFF

BINDING

Connecting transmitter and receiver:
The vehicle is ready to drive when it leaves the factory. In normal
circumstances, therefore, the binding function is not necessary!
1
ON OFF
Press and hold down the Binding button on
the receiver and then switch on the receiver.
The LED on the receiver then flashes rapidly!
1. Open the battery compartment lid on the underside of the
transmitter.
2. Insert fully charged rechargeable batteries or new AA bat-
teries observing the correct polarity. Close the cover on the
battery compartment again. Ensure that the cover clicks
properly into place. Check that it is in its correct position.
ON
1
ON
The binding function should only be used if there are any connec-
tion problems between the vehicle and the transmitter or if the
transmitter/receiver is replaced.
2
Press and hold down the Binding button
on the transmitter and then switch on the
transmitter.
3
ON OFF
LED
The binding process is completed when
the LED on the receiver is permanently
illuminated.
17 // GB