Télécharger Imprimer la page

Anslut 013517 Mode D'emploi page 19

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Max output
Power settings
Fuse
Ambient temperature
Protection rating
Max air volume
Air speed
DESCRIPTION
1.
Mode selector
2.
Thermostat dial
3.
Fan mode
4.
Low output mode + fan
5.
High output mode + fan
6.
Reset - to reset the overheating protection
FIG. 1
USE
INTENDED USE
The fan is intended to be used for temporary
heating of storerooms, buildings, workshops,
garages, barns and other similar dry places.
HOW TO USE
WARNING!
Do not cover the fan.
1.
Stand the fan upright on a flat surface at a
safe distance from flammable objects.
2.
Connect the fan to a power point.
3.
Set the thermostat in the MAX position
and turn the knob to full power. When
the required room temperature has been
4.
When the heater fan is used for the first time,
it may emit some smoke. This is normal and
stops after a while. The smoke comes from
400 V ~ 50 Hz
the thin coat of protective oil which is applied
9000 W
to the heater element during manufacture.
52/4500/9000 W
5.
16 A
-15 – +25°C
IPX4
1198 m³/h
4.4 m/s
The overheating protection switches off the
fan if it overheats. If this happens, pull out the
plug from the power point and allow the fan to
cool. The overheating protection must be reset
manually.
The overheating protection trips at a
temperature of 85°C.
Make sure the plug is pulled out from the
power point before cleaning and/or putting
away.
reached, turn the thermostat knob anti-
clockwise until the thermostat switches off.
The thermostat will now turn the heat on/
off automatically to regulate the room
temperature to the set value.
NOTE:
To switch off the product turn the
temperature dial to minimum and the
power dial to fan mode/low power, and
allow the fan to cool the product for 2
minutes before switching off the product
and pulling out the plug.
OVERHEATING PROTECTION
NOTE:
MAINTENANCE
IMPORTANT:
Disconnect the fan from the power point
and allow it to cool before cleaning.
Wipe the outside with a soft cloth
dampened with a mild soap solution.
Make sure not to get any water in the fan.
Wipe with a dry cloth.
NOTE:
EN
19

Publicité

loading