Secure The Safety Cable; Connect Power And Wall Controller Wiring - BIG ASS FANS 2025 Manuel D'installation

8. Secure the Safety Cable

The safety cable is a crucial part of the fan and must be installed correctly. If you have any questions, call
Customer Service for assistance.
A. Route the free end of the safety cable into one of the two holes in the Gripple®, and then pull the cable
through the Gripple until the Gripple rests at the top of the extension tube.
B. Wrap the safety cable tightly around the angle irons as shown, leaving as little slack as possible.
C. Route the loose end of the safety cable through the remaining hole in the Gripple and pull to tighten.

9. Connect Power and Wall Controller Wiring

Plug the male wiring harnesses on the fan wiring into the female wiring harnesses on the power supply cable and
the controller input cable as shown. Carefully tuck the wiring into the extension tube.
Controller Input Cable
Wall Controller Wiring
from Fan (8 wires)
Cover Plate Wiring from Fan
(4 wires, to be connected later)
16
ATTENTION
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
Power Supply
Cable
Power Wiring from Fan
(3 wires)
ALL RIGHTS RESERVED.