Publicité
Les langues disponibles
Les langues disponibles
CONTROLS AND OPERATION
This unit has a hybrid control panel with knobs for adjustment and a digital display to
monitor humidity and fan settings.
1. Plug cord into wall receptacle. Your humidifier is now ready for use.
2. Push in on the
FAN SPEED
3. Rotate the
clockwise to increase the fan
speed. The speed settings
will be shown on the LED
display, (F1 – F9).
NOTE: When excessive
condensation exists, a lower
speed setting is recommended.
HUMIDITY CONTROL
NOTE: Allow 10 to 15 minutes for
the humidistat to adjust to the room when setting up the unit for the first time.
NOTE: This model has an adjustable humidistat with settings from 25-65%. The
humidistat will turn the humidifier on when the humidity in your home is below the
humidistat setting and will turn the humidifier off when the humidity reaches the
humidistat setting. When set at 65%, the humidifier will operate continuously.
4. For initial operation, set the humidity knob
setting (45-50% is recommended) and adjust up or down
from there to achieve the desired humidity level. The digital
display will show the desired setting momentarily, and then
revert to displaying the actual humidity.
CONTROL PANEL DISPLAYS:
Several functions of the humidifier can be monitored through the LED display on
the control panel.
REFILL INDICATION:
5.
One bottle is designed to empty first. The letter F will flash
on the display, indicating the unit is entirely out of water.
6.
If the unit is not refilled within a few minutes, the Auto Dryout
feature will begin.
AUTO DRYOUT & SHUTOFF
7. At this time the unit will automatically switch into Auto Dry Out Mode and
continue to run on the lowest speed until the filter is completely dry. The fan
will shut off leaving you with a dry humidifier that is less prone to mold and
mildew.
knob to turn the unit on.
knob
at a midpoint
7
Publicité
