Aircare 696 Serie Guide D'utilisation Et D'entretien page 5

OPTIONAL AIR CLEANING FILTER (SOLD SEPARATELY)
6. Install the optional 1051(CN) AIRCARE
the unit. The filter has four tangs that engage into
four keyhole slots that mount the air filter
onto the outside of the back of the cabinet.
See page 8 for more information on the
AIRCARE ® air filter.
FLOAT INSTALLATION:
7. Using a Phillips head screwdriver,
CHASSIS INSTALLATION
8. Place the chassis/power pack unit into the cabinet, so it fits
NOTES ON LOCATION:
In order to get the most effective use from your humidifier, it is important to
position the unit where the most humidity is needed or where the moist air will be
circulated throughout the house such as near a cold air return. If the unit is
positioned close to a window, condensation may form on the window pane. If this
occurs the unit should be repositioned in
another location.
Place humidifier on a flat level surface. Do NOT
position the unit directly in front of a hot air duct
or radiator. Do NOT place on soft carpet. Due to
release of cool, moist air from the humidifier, it is
best to direct air away from thermostat and hot
air registers. Position humidifier next to an inside
wall on a level surface at least 2 inches away
from the wall or curtains.
Be sure that the humidistat, which is located on the power cord, is free from
obstruction and away from any hot air source.
FILLING INFORMATION
CAUTION:
In order to reduce the possibility of electrical shock, ensure the
control panel stays dry.
1. Your humidifier is equipped with two water bottles. Each bottle holds 2.75
gallons.
2. A fill hose that fits most faucets is provided with your humidifier. Fill the bottles with
cool, fresh (preferably unsoftened) water. If you only have softened water available
in your home, you can use it, but mineral buildup will occur more quickly.
NOTE: For optimum running time, fill each water bottle, tighten the cap, and place
inside unit. Do not fill the reservoir bucket, as overfilling will result in water
damage. Use only the bottles provided. One bottle will drain until the reservoir is
filled. Remove the partially emptied bottle and refill it. Place back in humidifier
cabinet.
CAUTION: When filling, be careful not to pressurize the bottle by overfilling it.
Bottle damage can result from this, and will not drain properly.
install the float support with float
inside into the base of the cabinet
with two screws supplied.
without tipping or rocking
® air filter at the back of
.
5