Table des Matières
Publicité
Listening to the radio
■ Tuning
1
Press the ON/STANDBY button to turn the power on.
2
Press the TUNER button (remote control) or
FUNCTION button (main unit) repeatedly to select FM
Stereo or FM Mono.
3
● Manual tuning:
Press the TUNING (
edly to tune in to the desired station.
● Auto tuning:
Press and hold the TUNING (
Scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING
(
or
) button again.
● When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed first, and then the
RDS indicator will light up. Finally, the station name
will appear.
● Full auto tuning can be achieved for RDS stations
"ASPM", see page 11.
To receive an FM stereo transmission:
● Press the TUNER button to select stereo mode. "ST"
indicator will be displayed. "
when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER button
to extinguish the "ST" indicator. The reception changes
to monaural, and the sound becomes clearer.
All manuals and user guides at all-guides.com
MICRO COMPONENT SYSTEM XL-LS701
or
) button repeat-
or
) button.
" and " " will appear
E-10
■ Memorising a station
You can store 40 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the "MEM" and preset number
indicators disappear before the station is memorised,
repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
■ To recall a memorised station
Press the PRESET (
or
station.
■ To scan the preset stations
1
Press and hold the PRESET (
preset number flashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
desired station is located.
■ To erase entire preset memory
1
Press the ON/STANDBY button to turn the power on.
2
Press the FUNCTION button (main unit) repeatedly
or TUNER button (remote control) to select Tuner
function.
3
In Tuner function, press and hold the CLEAR button
(remote control) until "Tuner Clear" appears.
) button to select the desired
or
) button until the
or
) button again when the
Publicité
Table des Matières
