Newage 66901 Mode D'emploi page 10

Safe Operating Practices
Don't push the electrical cable into grill enclosure
NewAge Grills are equipped with LED lighting on the control knobs and grill in-
terior, powered by an electrical cable on the rear of the unit. It's very important
not to push any excess cable into the hole at the back of the grill.
The grill enclosure gets extremely hot. Storing the cable in this manner can
cause it to bunch up and touch the underside of the burner box, which can
melt the electrical cable and become a serious hazard.
1. Locate the electrical cable on the back of your grill.
2. Ensure the excess cable is not pushed into the hole at the back of the grill,
and is fully extended outside the grill.
3. If the cable was inside the unit, pull the cable out and check for any damage
on the cord.
4. If you notice that your cable is damaged, call
1-877-306-8930; or support@newageproducts.com
10
Never let the gas hose touch your burner box
The underside of your grill gets incredibly hot. Pushing your excess gas line into the
cavity below your grill, or coiling it beneath the burner box can melt the exterior coat-
ing of the gas hose and cause a fire.
Whether your grill is connected to a natural Gas Line take these steps to make sure
your hose is positioned safely:
1. Ensure your grill is off and cooled down.
2. Kneel down and look in the cavity for the hose at the left-hand side of the grill.
3. If the hose is bunched up, or touching the firebox, pull the gas hose from the bot-
tom of the cabinet until any excess line is removed.
4. Check the hose for signs of melting or damage. If the damage has
occurred, or you are unsure of how to check, contact
1-877-306-8930; or support@newageproducts.com
Customer Support Team >
Customer Support Team >