GE Monogram ZBD6800 Manuel Du Propriétaire page 19

Questions? PROBLEM
Use this
Sanitized light does not
illuminate at the end of
problem
the cycle (Anti-Bacteria
solver
cycle only)
Interior lights not
working
End-of-cycle indicator
light does not illuminate completed cycle
Beeps every 30 seconds
START/RESET light blinks START/RESET pad was
Before You Call For Service
POSSIBLE CAUSE
The door was opened and • Do not interrupt the cycle any time during
the cycle was interrupted
during or after the main
wash portion
Low inlet water
temperature
Door was open for more
than 15 minutes
Bulbs are burned out
Dishwasher has not
Door was opened
during the cycle
pressed during the cycle
Power failure during
the cycle
Dishwasher
WHAT TO DO
or after main wash.
• Raise the water heater temperature to
at least 120°F (49°C).
• Latch the door and reopen.
• Call for service to replace bulbs.
• Open the door and check the status
indicator lights on control panel to
determine if cycle is complete.
• Close the door to complete the cycle.
• Dishwasher will pump out for approximately
70 seconds and blinking light will turn off.
• Dishwasher will pump out for approximately
70 seconds and blinking light will turn off.
Dishwasher will automatically restart using
NORMAL WASH and HEATED DRY.
19