Worx WX372 Notice Originale page 11

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for impact drilling in brick, concrete and stone as well as for drilling in
wood, metal and plastic.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and disconnect tool from power source when
changing accessories. Always ensure the bit is secure before starting the tool. Damage to the
Chuck or a loose bit may cause possible personal injury.
--Removing the bits
--Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION CONTROL
WARNING: Never change the direction of rotation when the
chuck is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING, HAMMER DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate for long periods at low speed
because excess heat will be produced internally.
Lithium-Ion cordless hammer drill
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig. C1, C2, C3
See Fig. D
See Fig. E
See Fig. F
EN
11