Publicité
Les langues disponibles
Les langues disponibles
¼" GAS
5.2. INSTALLATION OF THE BATTERY SUPPORT.
Once the battery has been installed it is recommended to set up special supports in order to hold the battery's weight as well as the weight of the
water that flows through it.
It is recommended to install adjustable height supports:
To install them it is first necessary to adjust the height of the clamps according to the battery and then fix the support to the floor with the
expanding bolt provided.
6. STARTING UP
•
Remove the lid of the filter trying not to damage the joints or the surrounding area around the lid.
•
Check that all the filter components are in good condition and ensure that the laterals or nozzle plate are secure, as they may have come
loose or been damaged in transit.
•
Fill the filter approximately half full of water.
•
Introduce the sand, ensuring you first pour in a support layer, enough to cover the groove of the laterals or nozzle plate, covering them by
approx. 10cm. This should be done very carefully so as not to damage any internal components. Whilst filling the filter with sand ensure that
you distribute the sand evenly over the whole surface area.
•
Introduce the desired sand size, up to the maximum filtration height limit.
•
Carefully clean the filter neck, the seal and the lid before proceeding with the assembly. It is also advised to grease the screws before putting
in the nuts, and once the lid assembly is complete, put the flanges (supplied with the filter) to the screws.
•
Close the filter placing the seal in its correct position.
•
Once the filter is full and properly closed, it is necessary to backwash the filter. To do this follow the instructions in the section labelled
'backwash'.
7. NORMAL WORKING CYCLE. (FIG.6)
FIG.5
TO THE
POOL
3
¼" GAS
DIFFUSERS
THE POOL
COLLECTORS
FIG.6
FROM
Publicité
