Tools Needed For The Assembly; Your 2 Channel Radio System - Carson Gas Devil Mode D'emploi

Tools needed for the assembly

GB
Modelling knife 74053
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 74023

Your 2 channel radio system

Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Batteries for receiver
Steering servo
6 CARSON Gas Devil 304015
010975_304015_betriebs_7k.indd 6 010975_304015_betriebs_7k.indd 6
Instant adhesive
Hexagonal wrench
Receiver
Receiver antenna
Switch
Engine throttle
servo
53339 Needle nose pliers
13118 Tool kit
Transmitter
74034 Scissors
908046 Side cutter
Transmitter antenna
13305
74035
05.07.2007 14:50:04 Uhr 05.07.2007 14:50:04 Uhr