Sentiotec VitaMy 164 Serie Instructions De Montage Et Mode D'emploi page 72

Instructions for installation and use
Fig. 34: Installation of the IR thermal plate VitaMy 164
Install the two IR thermal plates VitaMy 164 in the U-strips. The recess is used
to perform the management of the front beam (see Fig. 35)
When inserting the IR thermal plate, pay attention to the cable of the
switch; it has to not be pinched or damaged.
Fig. 35: Inserting the stiffener bar for the Vitamy IR thermal plates.
Lay the stiffener bar for the thermal plates from inside on the floor. Screw
the bar to the frame of the thermal plates. The recess is used to perform the
management of the front beam.
Screws
2 units: 3.5 x 50
p. 28/44