Panasonic TY-ST85PB1 Instructions D'installation page 27

Assembly
1. Assembling of the stand
1. Insert one support column ① to the
base ② and fix it with the support column
assembly screws Ⓐ (4). Assemble
the other support column in the same
procedure.
(Tightening torque: 1.8 to 2.2 N·m)
2. Lay down the assembled support column
as shown in the figure, and to its back
side, fix the fittings (top/bottom) ④ with
the fitting attachment screws Ⓒ (8) and
the insert nuts Ⓓ (8).
(Tightening torque: 1.8 to 2.2 N·m)
3. Raise the support column and fix the
other support column ① to the other side
of the fittings with the fitting attachment
screws Ⓒ (8) and insert nuts Ⓓ (8).
(Tightening torque: 1.8 to 2.2 N·m)
Support column ①
Base ②
Fitting (top) ④
Insert nut Ⓓ
Insert nut Ⓓ
Support column
assembly screw Ⓐ
Fitting (bottom) ④
Front side
Back side
Support column ①
Fitting attachment screw Ⓒ
Fitting
attachment
screw Ⓒ
Support column ①
27