203-610 Mm) Wide Flat Belt Conveyors; Install Gearmotor Mounting Package - Dorner MPB Serie Manuel D'installation

8–24¨ (203–610 mm) Wide Flat Belt
Conveyors
1. Locate return rollers. Exploded view shown in Figure
15.
Figure 15
1
2
Figure 15
2. Remove screws (Figure 15, item 1) and clips (Figure
15, item 2) from roller assembly.
3. Install roller assembly as shown (Figure 16, item 1).
Tighten screws (Figure 16, item 2) to 60 in-lb (7 Nm).
Figure 16
2
Figure 16
851-703 Rev. A

Install Gearmotor Mounting Package

2
1
1.
Figure 17
1
Aluminum Conveyors
9
A WARNING
Installing gearmotor without support under
conveyor can cause conveyor to tip, causing
severe injury.
PROVIDE SUPPORT UNDERNEATH THE
CONVEYOR WHEN INSTALLING THE
GEARMOTOR
Install gearmotor mounting package.
Figure 17
NOTE
For more detailed instructions on any
assembly or maintenance procedures, see
your Installation, Maintenance and Parts
Manual that is supplied with conveyor.
Assemble
Dorner Mfg. Corp.