Assemble
Figure 10
1
Mounting brackets for flat belt conveyors
shown.
Attach Conveyor to Stands
1.
Fasten brackets (Figure 11, item 1) to support stand
with mounting screws (Figure 11, item 2), washers
(Figure 11, item 3) and nuts (Figure 11, item 4).
Figure 11
4
3
2
2.
Tighten screws (Figure 11, item 2 and 5) to 60 in-lb (7
Nm).
3.
Attach to conveyor stand.
Dorner Mfg. Corp.
3
Figure 10
NOTE
5
Figure 11
Install Return Rollers
Cleated Belt and 2–6¨ (51–152 mm) Wide
Flat Belt Conveyors
1.
Locate return rollers. Exploded views shown in Figure
12 for flat belt and Figure 13 for a cleated belt.
Figure 12
2
1
Figure 13
1
2.
Remove screws (Figure 12, item 1) or (Figure
13, item 1) and clips (Figure 12, item 2) or (Figure
13, item 2) from roller assembly.
3.
Install roller assemblies (Figure 14, item 1) as shown.
Tighten screws (Figure 14, item 2) to 60 in-lb (7 Nm).
Figure 14
1
Aluminum Conveyors
8
2
Figure 12
2
Figure 13
2
1
Figure 14
2
1
2
1
1
851-703 Rev. A