Dexter power J1G-ZP28-255A-EU Notice De Montage - Utilisation - Entretien page 166

12. Fit the new blade onto the spindle taking care that the inner blade washer sits
behind the blade.
13. Replace the outer blade washer.
15. Use the 6 mm hex key to tighten the blade bolt securely (tighten in an anti-
clockwise direction).
16. Lower the blade guard, hold the rotating lower blade guard (6) and blade bolt
position.
17. Check that the blade guard operates correctly and covers the blade as the saw
arm is lowered.
18. Connect the saw to the power supply and run the blade to make certain that it is
operating correctly.
CROSS CUT
If possible, always use a clamping device such as a "G" clamp to secure your workpiece.
When cutting your workpiece, keep your hands well away from the blade area.
A crosscut is made by cutting across the grain of the workpiece. A 90°crosscut is made
with the mitre table set at 0°. Mitre crosscuts are made with the table set at some angle
other than zero.
1. Pull on the release knob (2) and lift the saw arm (1) to its full height.
2. Loosen the mitre locks (18) and lifting up the mitre latch(19) .
3. Rotate the mitre table (14) until the pointer aligns with the desired angle.
4. Release mitre latch(19) and retighten the mitre locks (18).
If the board is warped, place the convex side against the fence (12). If the concave side
is placed against the fence, the board could break and jam the blade.
6. When cutting workpiece, support the opposite end of the workpiece with side
support bars, a roller stand or a work surface that is level with the saw table.
7. Before turning on the saw, perform a dry run of the cutting operation to check that
there are no problems such as a clamp interfering with the cutting action.
trigger (17). Allow the blade to reach maximum speed and slowly lower the blade into
and through the workpiece.
9. Release the switch trigger (17) and allow the saw blade to stop rotating before
raising the blade out of the workpiece. Wait until the blade stops before removing the
workpiece.
162
FR
ES
PT
IT
EL
EN