Dexter power J1G-ZP28-255A-EU Notice De Montage - Utilisation - Entretien page 164

BEVEL LOCK
The bevel lock (10) is used to set the blade at the desired bevel angle. The mitre saw
bevel cuts from 0° to 45° to the left. To adjust the bevel angle loosen the bevel lock
and adjust the saw arm to the desired bevel angle.
SPINDLE LOCK BUTTON
The spindle lock button (20) prevents the blade in the saw from rotating. Depress and
hold the spindle lock button while installing, changing, or removing the blade.
ROTATING LOWER BLADE GUARD
The rotating lower blade guard (6) provides protection from both sides of the blade.
It retracts over the upper blade guard (4) as the saw is lowered into the workpiece.
TURNING ON AND OFF
(17).
DUST EXTRACTION
1. Fit the dust bag (9) to the dust extraction port.
2. A vacuum dust extraction device can be connected to the dust extraction port. Use a
suitable vacuum adaptor if necessary. The dust extraction port has an internal diameter
of 40 mm.
SETTING THE TABLE SQUARE WITH THE BLADE
1. Make sure that the electrical plug is removed from the power point.
2. Push the saw arm (1) down to its lowest position and engage the release knob (2) to
hold the saw arm in the transport position.
3. Loosen the mitre locks (18) and lifting up the mitre latch(19) .
4. Rotate the table (14) until the pointer is positioned at 0°.
5. Release mitre latch(19) and tighten the mitre locks (18).
6. Loosen the bevel lock (10) and set the saw arm (1) at 0°bevel (the blade at 90°to the
mitre table). Tighten the bevel lock (10).
8. Rotate the blade by hand and check the blade-to-table alignment at several points.
9. The edge of the set square and the saw blade should be parallel.
10. If the saw blade angles away from the set square, adjust as follows.
11. Use an10 mm wrench or adjustable wrench to loosen the lock nut securing the 0°
bevel adjustment screw (27). Also, loosen the bevel lock (10).
12. Adjust the 0° bevel adjustment screw (27) using a 4 mm hex key to bring the saw
blade into alignment with the square.
160
FR
ES
PT
IT
EL
EN