Cleaning And Maintenance - ARO SHG5056 Notice D'utilisation

CLEANING AND MAINTENANCE

By ensuring proper cleaning and mainte-
nance of your cooker you can have a sig-
nificant influence on the continuing fault-free
operation of your appliance.
Before you start cleaning, the cooker must
be switched off and you should ensure
that all knobs are set to the off position.
Do not start cleaning until the cooker has
completely cooled.
Burners, the burner hob grate, the cooker
housing
• In the case of soiled burners and grate,
these elements must be removed from
the cooker and washed with warm water
and washing – up products intended for
fats and soils. Next, wipe them dry. After
the grate has been removed, wash the
burner hob carefully and wipe with a dry
and soft cloth. In particular, ensure flame
openings in rings under caps are clean,
see the figure below. Do not use steel
wire or drill holes.
Caution!
Burner elements must always be clean. Water
particles may hamper gas flow and produce
an incorrect burner flame.
Important:
The burner caps and leads must be reposi-
tioned correctly so that they sit squarely onto
the hob as shown.
correct
incorrect
incorrect
• Wash enamel elements of the cooker
with light washing products. When clean-
ing do not use cleaning agents with a
strong abbrasive effect, such as scour-
ing powders containing an abrasive,
abrasive compounds, abrasive stones,
pumice stones, wire brushes and so on.
• Before you start using the cooker with
stainless steel hob, its cooking zone
first needs to be carefully washed. It is
important to remove glue residues from
the foils taken off trays during installation,
as well as adhesive tape applied during
packaging. The hob should be cleaned
regularly after each use. Do not allow
the hob to get heavily stained, particu-
larly from burnt-on spillages from boiled
over liquids. An agent like Stahl-Fix is
recommended for the initial wash and,
subsequently, for routine washes.
29