ARO SHG5056 Notice D'utilisation page 18

INSTALLATION
Install the anti-tip bracket.
To prevent the appliance
tipping over, install the anti-
B
A
-tip bracket provided with the
appliance by following the
instructions below.
Drill a hole at a height of 6
cm from the floor (A) on the
wall, where the appliance will
be installed. Then drill the
second hole at the height of
10.3 cm from the floor (B).
Using the 2 wall anchors and
screws provided, attach the
anti-tip bracket to the wall
by aligning it with the drilled
holes.
18