ARO SHG5056 Notice D'utilisation page 19

INSTALLATION
Gas connection
Caution!
The cooker should be connected to a
gas supply of the particular type of gas
that the appliance is manufactured to
function with. Information about the
type of gas that the cooker has been
adapted to by the factory is shown on
the data plate. The cooker should be
connected exclusively by an appropri-
ately authorised fitter and only he or
she has the right to adapt the cooker
to a different type of gas.
Fitting guidelines
A fitter should:
• have a gas fitter's authorisation,
• be acquainted with the information in-
cluded on the data plate of the cooker
about the type of gas to which the cooker
is adapted; the information should be
compared with gas supply conditions at
the place of installation,
• check:
- airing efficiency, that is efficiency of
air exchange in the rooms,
- tightness of gas fitting connections,
- effectiveness of all functional ele-
ments of the cooker,
- if the electricity supply is adapted to
function with a safety ground lead (zero).
• provide the user with a connection cer-
tificate and give him or her instructions
in cooker use.
The cooker has threaded 1/2" pipe connector.
19
Gas inlet
at the rear
of the cooker G 1/2"
Parallel thread
with a ISO 228-1
Flexible connector
with pilot (including the
seal)
Gas inlet
at the rear
of the cooker G 1/2"
Parallel thread
with a ISO 228-1
Seal
Flexible connector
with pilot