The Brakes; Service; Maintenance; To Clean The Product - Kayoba Breaker 1.2 2022 Instructions D'utilisation

Vélo tout-terrain
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
Note! Do not switch the chain to its outer position: The large
front chain ring and large cassette sprocket, or the small
front chain ring and small cassette sprocket. That cause
much wear and damage to the gear system.
● Only change gear when the crank arms and wheels move
forward.
● Do not force the gears.
● Do not change gear if you push down hard on the pedals.
Note! Change gear down before it is necessary. You must be
able to pedal forward when you change gear.
Note! Change gear down before you stop the product. That
makes it easier to start the bike.
Note! Do not pedal rearwards when you change gear.

4.4 The brakes

Warning! Do not use a product with brakes that do
not operate correctly.
● The product has rim brakes and 2 brake handles. 1 brake
for each wheel.
● The brake handles are located on the 2 sides of the
handlebar.
• The left hand-brake handle controls the front wheel.
• The right hand-brake handle controls the rear brake.
4.4.1 To use the brakes
● Apply the rear brake before you apply the front brake.
Warning! Do not apply the front brake when you turn
the product or on a slippery surface.
5

Service

● To make sure that the product is safe to use. Only use
original spare parts when you replace parts that are
applicable for safety.
● Let an authorized service center do service to the
product every 6 months. Do service on the product more
often if it is necessary.
● Make sure that all screws are correctly tightened and that
the wires are installed correctly to the frame and not
damaged after adjustments are made.
● Let an authorized service center do service to shock
absorbers. Refer to the instructions from the shock
absorber manufacturer.
2022_001
6

Maintenance

6.1 To clean the product

● Clean the product regularly.
● Clean with a mild detergent. Do not use degreasing
products that can penetrate the bearings and chain and
interfere with the lubrication.

6.2 To lubricate the chain

The chain should be lubricated at regular intervals. If the
chain is dry, it can rust and get damaged.
1
Lubricate the chain with applicable chain oil.
2
Move the pedal a few turns, to let the oil go into the
link.
3
Wipe the chain with a cloth.

6.3 To adjust the brake handle

The brake should apply full power when the brake handle is
pushed halfway. The brake must not press against the rim
when the brake handle is not pressed. The handle must not
be pressed fully to the handlebar.
● Turn the adjusting sleeve in the brake handle to increase
or reduce the movement of the brake handle. (Figure 8)
● If larger adjustment is needed, release the wire lock on
the brake arm. Move the wire to required position and
fully tighten the wire lock. (Figure 9)
● To replace the brake wires, speak to an authorized
service center.

6.4 To adjust the spring tension

The spring tension prevents that the brake touches the rim
when the brake handle is released.
● Turn the adjusting screws on each side of the brake with
a suitable screwdriver until the arms move in parallel.
(Figure 10)

6.5 To adjust the brake pads

The brake pads should press against the middle of the rim.
The brake pads must not touch the tyre or move below the
bottom edge.
● If it is necessary, loosen the hex screw that holds the
brake pad and adjust the position of the pad. (Figure 11)
● If it is necessary, replace the brake pads. Speak to an
authorized service center.
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

006381

Table des Matières