To Assemble The Pedals; Operation; To Do Before Operation; To Adjust The Saddle - Kayoba Breaker 1.2 2022 Instructions D'utilisation

3.5 To assemble the pedals

Note! The right pedal is marked with a R, and the left pedal
is marked with a L. Install the right pedal on the right side of
the bike, and the left pedal to the left side of the bike. If the
pedals are not installed correctly, it can cause damage to
the threads on the pedals.
Note! Put grease on the threads on the pedals before
installation.
3.5.1 To fit the right pedal
1
Turn the pedal clockwise on the chain side of the
crank arm.
2
Tighten with a 15 mm combination spanner.
(Figure 4)
3.5.2 To fit the left pedal
1
Turn the pedal counter-clockwise, on the opposite
side of the chain side of the crank arm.
2
Tighten with a 15 mm combination spanner.
(Figure 5)
4

Operation

4.1 To do before operation

● Make sure that the product is adjusted correctly.
(Figure 6)
● Make sure that the product is assembled with brakes and
a bell.
● Make sure that the product has a front lamp with a white
light and a rear lamp with a red light. Make sure that the
lamps can lit.
● Do a check that the reflectors of the product are correctly
installed, clean and not obscured. Replace damaged
reflectors.
● Learn how to use the components and accessories on
the product correctly. If you do not learn how to use the
brakes on the product you can get seriously injured.
● Make sure that the brakes stop the wheels when they are
applied. Make sure that the brake pads are not worn out.
● Make sure that all screw and components are tight and
correctly installed.
● Make sure that the wheels are correctly installed in the
front fork and the rear fork.
26
● Make sure that the rims are not damaged.
● Make sure that the tyres are not damaged. Make sure that
the tyres have the correct air pressure.
● Make sure that the steering moves correctly.

4.2 To adjust the saddle

● Make sure that the saddle is comfortably adjusted.
4.2.1 To adjust the height of the saddle
1
Open the quick-release lever (A) on the saddle tube.
(Figure 7)
2
Move the saddle post to the required height (B).
3
Close the quick-release lever.
Note! Make sure that the marking for the top position on the
saddle is below the edge of the saddle tube.
4.2.2 To adjust the saddle horizontally
1
Release the knot that holds the saddle to the saddle
post.
2
Adjust the position of the saddle forward or rearward.
Move the saddle with small adjustments to find the
correct position.
Note! If you have your foot on the pedal with the crank arm
horizontal, the pedal should stay below the knee.
3
If it is necessary, adjust the angle of the saddle.
4
Tighten the knot that holds the saddle to the saddle
post.

4.3 The Gears

4.3.1 External gears
The product has external gears. The chain moves between
the different sprockets on the cassette.
● Make sure that the gears are correctly adjusted.
4.3.2 To change gear
● Use the left-hand gear shift to switch between the chain
rings on the chain set.
● Use the right-hand gear shift to switch between the
different sprockets on the cassette.
2022_001