Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When
replacing the battery
pack, do not insert the
battery until the Grinding/
Cutting Disc comes to a
complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting
12
Disc
Adjusting Wheel Guard
NOTE: Before any work on
the machine itself, remove
the battery pack. For work
with grinding or cutting
discs, the protection guard
must be mounted. Use the
correct type of disc for your
application. If the power
tool is intended to perform
cutting off operations,
a guard specific for this
operation must be fitted.
The coded projection on the
wheel guard ensures that only a
guard that fits the machine type
can be mounted.
Open the clamping lever. Place
the wheel guard with coded
projection into the coded
groove on the spindle of the
machine head and rotate to
the required position (working
position).
To fasten the wheel guard, close
the clamping lever.
The closed side of the
wheel guard must always
point to the operator.
20V Cordless Brushless Angle Grinder EN
OPERATION
Using On/Off Switch
Hand Grip Areas
Rough Grinding
NOTE: Electronic anti-
kickback
technology stops the blade
when a jam is detected.
roughing.
FIGURE
Cutting
WARNING: Wheel Guard For
See Fig. A1
Cutting must be assembled
before performing cutting
See Fig. A2
off operations.
WORKING HINTS FOR YOUR
See Fig. A3
ANGLE GRINDER
1. Always start at no load to achieve maximum
2. Do not force the disc to work faster, reducing the
See Fig. B
3. Always work with a 15-30° angle between disc
See Fig. C1,
C2, C3
4. When using a cutting disc never change the
5. When cutting very hard material best results can
6. When using a diamond disc it will become very
See Fig. D
7 . Always ensure the workpiece is firmly held or
TROUBLE SHOOTING
Although your new angle grinder is really very
simple to operate, if you do experience problems,
please check the following:
1. If your grinder wheel wobbles or vibrates, check
2. If there is any evidence that the wheel is
WARNING! Never use a
cutting disc for
speed then start working.
disc's moving speed means longer working time.
and workpiece. Larger angles will cut ridges into
the workpiece and affect the surface finish. Move
the angle grinder across and back and forth over
the workpiece.
cutting angle otherwise you will stall the disc
and angle grinder motor or break the disc. When
cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of
the cut slot.
be achieved with a diamond disc.
hot. If this happens you will see a full ring of
sparks around the rotating disc. Stop cutting and
allow to cool at no load speed for 2-3 minutes.
clamped to prevent movement.
that outer flange is tight; check that the wheel is
correctly located on the flange plate.
damaged do not use as the damaged wheel may
disintegrate, remove it and replace with a new
wheel. Dispose of old wheels sensibly.
See Fig. E
See Fig. F
See Fig. G
See Fig. H
Publicité
