Theory Of Operation; Basic Operation - Greenlee Circuit Seeker CS-5000 Manuel D'instructions

Theory of Operation

The CS-5000 transmitter is intended for connection to an electrical line (up to 600 volts) or
other metallic object. The transmitter signal consists of a controlled frequency with a specific
modulation and timing that is different for live and open circuits. This composite signal gives it a
specialized signature.
The transmitter signal generates a corresponding magnetic or electrostatic field signature around
the conductor being traced. This field signature is present the entire length of the conductor,
including breakers, fuses, switchgear, and transformers.
The CS-5000 receiver is tuned and programmed to pick up only the field signatures produced
by the transmitter. To be received, the signal must have this exact frequency, modulation, and
timing. This feature greatly reduces the possibility of interference from electrical noise, which is
often caused by lamps, appliances, fluorescent fixtures, or machinery that is on the same line.
Both the transmitter and the receiver are microprocessor-controlled for maximum ease of use
and accuracy.

Basic Operation

These instructions provide the user with a basic understanding of how the unit functions. These
tests are best performed at a desk or bench.
Transmitter
1. Push and release the Power button. The Power LED illuminates, indicating unit power and
signal being sent.
2. Plug the unit into any energized outlet. The LIVE LINE LED also illuminates, indicating that the
transmitter is connected to an energized circuit.
3. The transmitter is left on for the Receiver test. When finished with the Receiver test, unplug
the unit. Push and release the Power button to turn the unit off.
Receiver
1. Push and release the Power/Signal Reset button to turn the receiver on.
2. The Relative Signal Strength LEDs will all be illuminated, indicating the receiver is
searching for a signal. The display will indicate the unit is set to "BREAKER MODE" by the
green LED under BREAKER.
3. Push and release the Mode Selector button. The green LED will change from BREAKER
to SEARCH. This button toggles between the two available settings. Whenever this
button is pushed, the signal strength automatically resets.
4. Push and release the up or down arrow button.
5. Push and hold the Power/Signal Reset button to turn the receiver off.
CS-5000
5
9