Greenlee Circuit Seeker CS-5000 Manuel D'instructions page 10

Basic Operation (cont'd)
Using the Transmitter and Receiver as a Set
1. Connect a cord to the transmitter. Push and release the Power button.
2. Hold the receiver approximately six inches from the cord, and then push and release the
receiver's Power/Signal Reset
7 red LEDs illuminated and there will be an audible signal.
3. Push and release the Mode Selector button to toggle to "SEARCH MODE." Moving the unit
back and forth or to and from the transmitter cord will demonstrate how the Relative Signal
Strength LEDs operate. The tracing method is set to Auto Gain so it will fine tune, creating less
range but more definition as you get closer to the transmitter cord. The Relative Signal
Strength LEDs can be reset to full level at any time by pushing and releasing the
Power/Signal Reset
4. With all Relative Signal Strength LEDs illuminated, push the Manual Gain
Manual Gain
The green "BREAKER" or "SEARCH" LED will change from blinking to solid.
Push Manual Gain to reduce the number of Relative Signal Strength LEDs illuminated,
or Manual Gain
The signal will remain at the same fixed reference setting until the unit is reset using the
Power/Signal Reset button.
Push and hold the Power/Signal Reset
5.
Power button to turn the transmitter off.
10
button. The Relative Signal Strength Indicator will have all
button.
which will change from the Auto Gain method to the Manual Gain method.


 to increase the number of Relative Signal Strength LEDs illuminated.
button to turn the receiver off. Momentarily push the
or

5