Greenlee Circuit Seeker CS-5000 Manuel D'instructions page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important Safety Information
Electric shock and fire hazard:
Do not expose this unit to rain or moisture.
Do not use the unit if it is wet or damaged.
Use only test leads or accessories that are approved for the application.
Inspect the test leads or accessory before use. They must be clean and dry, and the
insulation must be in good condition.
Use this unit for the manufacturer's intended purpose only, as described in this manual. Any
other use can impair the protection provided by the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
The transmitter Live Line indication does not function if the batteries are dead or removed.
Test on a known live circuit before use.
Do not apply more than the rated voltage between any two input terminals, or between any
input terminal and earth ground.
Do not contact the test lead tips or any uninsulated portion of the accessory.
Using this unit near equipment that generates electromagnetic interference can result in
unstable or inaccurate readings.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
Do not operate with the case or battery compartment open.
Before opening the case or battery compartment, remove the test leads from the circuit and
shut off the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
Do not attempt to repair this unit. It contains no user-serviceable parts.
Do not expose the unit to extremes in temperature or high humidity. Refer to
"Specifications."
Not for use outdoors or wet locations.
Failure to observe these precautions may result in injury and can damage the unit.
CS-5000
5
5

Publicité

Table des Matières
loading

Table des Matières