Seko TEKNAEVO TPG Manuel D'installation page 4

Setting the Language
Programming
PROG
Pump Functions
-
Max flow rate
P100%
-
Alarm Relay
N.Open
-
Language
English
-
Paragraph 1 – Manual Dosage
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
Display during Operation
Operating mode
 Man = Manual
MAN
Lev
Alarms and statuses

Lev = Level alarm

Flw = Flow alarms
 Empty = pump in start
 Stop = pump stationary
 Paus = pump in pause
Paragraph 2 - Dosage Proportional to Signal 0/4-20
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
0/4 - 20 mA
-
0/4 - 20 mA
Low 4.0mA
-
-
0/4 - 20 mA
High 20.0mA
-
EM00136061
All manuals and user guides at all-guides.com
-
+
-
The pump operates in constant mode. The flow can only be manually
regulated by pressing the
the flow, or the
FLOW sensor
status
Current dosage speed
(depends on selected unit of
measurement)
F F F
 Percentage, Frequency,
Stop P100%
l/h, Gph, ml/m
Pump status
The pump proportionally doses at a signal of (0)4-20 mA. On the basis of
the factory settings, the pump interrupts dosage at 4mA and doses at the
maximum set frequency when it receives 20 mA. These two values can be
modified during programming. The maximum frequency can be modified
during operation, by pressing the
+
increase the flow, or the
+
rev. 2.5
Operation
Makes it possible to select the language. The pump is set in
English in the factory.
Changes can be made by pressing the
using the keys to set the new value. Press
confirm and return to the main menu
Operation
keys at the same time to increase
keys to decrease it.
Display during Setting (MODE key)

Man (during manual modification of the
flow it displays the corresponding
frequency value)

Modify the maximum flow by pressing the
+ or – keys at the same time
Operation
EN
key, then
Operating mode
MAN
P100%
Current dosage value
keys at the same time to
keys to decrease it.
to
3