Seko TEKNAEVO TPG Manuel D'installation page 10

Paragraph 10 – Setting the Alarm Relay
Programming
PROG
Pump Functions
-
Max flow rate
P100%
-
Alarm Relay
N.Open
-
Paragraph 11 – Flow Calibration
Programming
PROG
-
-
Pump Calibration
0,23 cc/stroke
Pump Calibration
Pump Calibration
cc/stroke
Manual
-
Automatic Cal.
Pump Calibration
Automatic Start 100 strok.
-
Automatic Cal.
Strokes
Automatic Cal.
ml
Paragraph 12 - Statistics
Programming
EM00136061
All manuals and user guides at all-guides.com
In the absence of an alarm situation, it can be set as open
(default) or closed.
Changes can be made by pressing the
the
-
confirm and return to the main menu
+
-
The memorized cc value per strike appears in the main
menu. It can be calibrated in two different ways:
MANUAL – manually enter the cc value per strike using the
AUTOMATIC – the pump makes 100 strikes, which are
-
started by pressing the
+
0,23
enter the quantity sucked up by the pump using the
keys and confirm by pressing the
The entered figure will be used in flow calculations.
100
-
+
20
The main menu displays the pump operation times. By
pressing the
- Strokes = number of strokes made by the pump
- Q.ty (L) = quantity dosed by the pump in litres; this figure is
calculated on the basis of the memorised cc/stroke value
- Power = number of pump starts
- Reset = use the
otherwise (NO), then confirm by pressing the
Pressing the
rev. 2.5
Operation
keys to set the new value. Press
Operation
keys and confirm by pressing the
key. At the end of this process,
Operation
key you can access other statistics:
to reset the counters (YES) or
key will take you back to the main menu.
EN
key, then using
to
key
key.
key.
9