SERVODAN 41-340 Notice D'utilisation page 7

Set-up/commissioning
The Presence detector 360° is supplied with a PIR test function.
a) PIR TEST mode, PIR go test.
Turn the DIP2 switch to "on".
At this setting the lighting will be switched on for fi ve seonds
as a result of PIR activation, and at the same time the
integrated indicator (LED) will indicate that PIR is activated.
Finish by turning the DIP2 switches to "off".
b) LED indication ON, Indication of PIR activation.
Turn the DIP1 switch to "on". It is recommended that you set
this at "off" if you do not want to indicate monitoring.
c) PIR sensitivity setting.
Switches DIP3 and DIP4 enable you to customise the sensor's
sensitivity. In the factory the product is set to high sensitivity.
It might therefore be necessary to change this in certain
circumstances. The options are described in Fig. 7
The PIR Sensor is preset in the factory:
• LED is switched off
• High sensitivity
• Cut-out delay 1 min.
Maintenance
Make sure that the lens is kept clean and dry. The lens can
be cleaned with a slightly damp cloth. In the event of faults or
operational disruption beyond the normal user settings TIME,
SENSITIVITY, contact an authorised electrician.
Technical data
Input:
Supply voltage ......................................24 V DC±10%
Stand by consumption ........................approx. 0.25 W
Max. inherent consumption ................approx. 0.75 W
Output:
Relay contact .......................................0.5 A 24 V DC,
Preformance:
Lux range ..............................................30...3000 lx
Light sensor signal ...............................0-10 V (Source) Ri > 2 K
Cut-out delay ........................................1-30 mins
Sensitivity .............................................Selected manually
Activation indicator on/off ....................Selected manually
Test mode .............................................Selected manually
Protection class ....................................IP 20
Ambient temperature ............................-5°C...+50°C
Cable input ...........................................2 x Ø12 mm
Installation height .................................2,5 - 3,4 m, see Fig. 1
Approval:
CE according to ....................................EN 60669-2-1
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com
NO dry contact
41Y340_03_R4_021031KOE0947 41Y340_03_R4_021031KOE0947
GB
7(11)