Ibiza Light LMH410Z Manuel D'utilisation page 7

TILT - Adjustment of the tilt position.
1. Press the ENTER button for at least 5 seconds, then press the UP or DOWN buttons so that "TILT" is displayed,
press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and then press ENTER to confirm. Press the MENU
button for one second to exit.
Operation
Universal DMX Control:
This function allows you to use a universal DMX-512 controller to control the master dimmer, rotation and color. A
DMX controller allows you to create unique programs tailored to your individual needs.
1. The moving head has 3 DMX Modes. 10, 12 & 15 Channels. See the detailed description of the DMX values and
traits
2. To control your fixture in DMX mode, follow the set-up procedures as well as the set-up specifications that are
included with your DMX controller. Follow the instruction to set the DMX Address.
3. Use your DMX controller's faders to control the various DMX fixture traits.
4. Follow the instructions to set your DMX channel mode and the DMX address.
5. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
6. For help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode:
This mode allows either single unit or several units linked together, to run to the beat of the music.
1. Press the MENU button until "SOUN" is displayed, and press ENTER. Press the UP or DOWN buttons so that "ON"
is displayed and press ENTER.
2. Press the MENU button until "SENS" is displayed, and press ENTER. Use the UP and DOWN buttons to adjust the
sound sensitivity. Press ENTER when you have found your desired sensitivity level.
Show Mode:
This mode allows either a single unit or several units linked together, to run one of four shows that you choose.
1. Press the MENU button until "SHND" is displayed, and press ENTER.
2. Press the UP or DOWN buttons to find your desired show, and press ENTER.
Master-Slave Set Up
Master-Slave Configuration This function will allow you to link up to 16 units together and operate without a
controller. In a Master-Slave set up one unit will act as the controlling unit and the others will react to the controlling
units programs. Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear of the units.
Remember the Male XLR connector is the input and the Female XLR connector is the output. The first unit in the
chain (master) will use the female XLR connector only - The last unit in the chain will use the male XLR connector
only. For longer cable runs we suggest a terminator at the last fixture.
2. On the Master unit press the MENU button until "SLND" is displayed, and press ENTER. Use the UP and DOWN
buttons to scroll to the "MAST" setting and press ENTER.
3. After setting the Master unit to the master setting find your desired operating mode.
4. On the slave units press the MENU button until "SLND" is displayed, and press ENTER. Choose either "SL 1" or "SL
2" and press ENTER.
5. The slave units will now follow the Master unit.
©Copyright LOTRONIC 2016 LMH410Z Page 7