Fixture Linking - Ibiza Light LMH410Z Manuel D'utilisation

Features
• 10 / 12 / 15 DMX channels
DMX, music controlled and show modes
•
4 built-in shows
•
• Built-in mic
Digital display for address and function setting
•
Specifications
Power supply ...................................................................................... 100-240Vac 50/60Hz
Consumption ............................................................................................................... 67W
LED ................................................................................................... 4 x 10W 4-in-1 RGBW
Pan............................................................................................................................... 540°
Tilt ............................................................................................................................... 180°
Beam Angle .............................................................................................................. 10-60°
Dimensions .......................................................................................... 180 x 150 x 240mm
Weight ........................................................................................................................ 3,2kg
Mounting
ORIENTATION
This fixture may be mounted in any position
provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of
the base, the included 'omega bracket' and the
safety cable rigging point in one unit (see the
illustration on the right).When mounting this
fixture on a truss, be sure to use an appropriate
clamp with the included omega bracket using a
M12 screw fitted through the center hole of the
'omega bracket'. As an added safety measure, be
sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable
rigging points integrated in the base assembly.
SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.

Fixture Linking

You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 100 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 16 fixtures
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.
©Copyright LOTRONIC 2016 LMH410Z Page 3