Function Mode - Ibiza Light LMH410Z Manuel D'utilisation

TILT
BALA
MANU
TEST
RSET

Function Mode

DMX address setting
1. Press the the MENU button until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. When you have found your desired DMX address press ENTER then press and hold the MENU button for at
least 3 seconds to store your desired DMX address.
3. Connect your DMX Controller.
CHnd - This will let select your desired DMX channel mode.
1. Press the MENU button until "CHnd" is displayed, press ENTER. Either "10CH", "12CH", "15CH" will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm and exit.
SLnd – Master-Slave configuration
1. Press the MENU button until "SLnd" is displayed, press ENTER. Either "MAST", "SL 1", "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, and press ENTER to confirm.
SHnd—Show mode 1-4 (factory set programs). The show mode can run with our without sound active mode.
1. Press the MENU button until "SHnd" is displayed, press ENTER.
2. "SH X" will now be displayed, Select 1-4 to choose your program
3. When you have found your desired show press ENTER, then press and hold the MENU button for at least 3
seconds to activate.
SoUn – Sound active mode
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to activate sound active
mode, or "OFF" to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at least 3 seconds to activate.
Sens - Sound sensitivity
In this Mode a number between 0-100will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity, 0 being the least sensitive and 100 being the most sensitive. Press ENTER to confirm.
BLnd – Standby mode
1. Press the MENU button until "BLnd" is displayed, press ENTER.
2. The display will show either "NO" or "YES". Choose your desired mode.
3. Press ENTER.
LED – Display back light will turn off after 2 minutes
1. Press MENU until LED is displayed. Press ENTER
3. Press<Up/Down> to choose 'ON' or 'OFF'. If "ON" is selected, the back light stays on all the time.
4. Press <Enter> and "MENU" for at least three seconds.
©Copyright LOTRONIC 2016
YES , NO (TIL2 Reverse)
Red, green, blue, white balance
PAN, TILT, ZOOM, RED, GRENN, BLUE, WHITE, DIMMER, STROBE
AUTO TEST
YES, NO Restore factory settings
LMH410Z Page 5