VATECH EzRay Air Portable Manuel D'utilisation page 41

Charging the Battery
1. Connect the battery charger to the battery charger connector as shown in the
following figure.
2. When the battery charger is connected, the battery charging LED indicator light
comes on. Charge the battery until all the three LED indicators are filled up.
3. When the battery charge is completed, remove the battery charger from the
device.
Battery Use Cycle
The battery is a consumable part. It is expected to degrade gradually, so it should be
recharged more frequently. When the battery duration decreases to half or less than
half compared to when the battery was new, contact your Service Representative to
get a new battery.
To check how to replace the battery, see 'Battery Replacement'.
EzRay Air Portable (Model: VEX-P300) User Manual
Usually, it takes about 3 hours to charge the battery after a
complete discharge fully.
It is not able to perform an exposure while the battery charger
is connected to the device.
4. Operation
35