Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LIFEBOOK AH532 Guide D'utilisation

Removing a Memory Upgrade Module

Perform steps 1 through 4 of Installing a Memory Upgrade Module.
1
Pull the clips sideways away from each side of the memory upgrade module at the same time.
2
While holding the clips out, remove the module from the slot by lifting it up and pulling it away from your
3
notebook. (Figure 32)
Store the memory upgrade module in a static guarded sleeve.
4
Replace the cover and reinstall the screws.
5

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger
one, be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] -> Control Panel -> System and Maintenance -> System. The amount
of memory is displayed next to "Memory - RAM:"
There may be a variation between the actual memory size and what is displayed. This is possible if your system is
configured with an integrated Intel Graphics Media Accelerator which dynamically allocates system memory to
accelerate graphics performance.
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT CORRECTLY RECOGNIZED
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS PROPERLY INSTALLED
,
SEE
60 - Memory Upgrade Module
T 65 .
ROUBLESHOOTING ON PAGE
. (I
F THE MODULE IS