Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LIFEBOOK AH532 Guide D'utilisation

Memory Upgrade Module

Your Fujitsu LIFEBOOK notebook comes with a minimum of 4 GB of high speed Double Data Rate Synchronous Dynamic
RAM (DDR3-1600 SDRAM factory installed. To increase your notebook's memory capacity, you may install an additional
or larger memory upgrade modules. The memory upgrade must be a dual-in-line (DIMM) SDRAM module. To ensure
100% compatibility, purchase the SDRAM module only from the Fujitsu web store at www.shopfujitsu.com
D
•
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES SPECIFICALLY SHOWN IN THE DIRECTIONS
FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE
T
•
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
THE FOLLOWING PRECAUTIONS
B
•
EFORE HANDLING A MEMORY MODULE
W
•
HEN INSTALLING OR REMOVING A MEMORY MODULE
TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS
B
•
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
STATES

Installing Memory Upgrade Modules

T
HE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK
IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM MEMORY CAPACITY
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
1
Turn the notebook bottom side up, and remove the five screws from the large memory upgrade module
2
compartment (Figure 29). Remove the cover (Figure 30).
Remove the new memory upgrade module from the static guarded sleeve.
3
Align the memory upgrade module with component side up (Figure 31). Align the connector edge of the upgrade
4
module with the connector slot in the compartment. Be sure the alignment keys line up with those in the slot.
:
,
DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
.
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
.
58 - Memory Upgrade Module
(ESD). T
O MINIMIZE RISK TO THE MODULE
. E
VEN IF THE SYSTEM IS IN HIBERNATE OR STANDBY
.
. O ,
NCE IT IS INSTALLED YOU SHOULD LEAVE IT
.
,
OBSERVE
.
. B
E CAREFUL NOT
.