Memory Upgrade Module; Installing A Memory Module - Fujitsu LIFEBOOK NH532 Guide D'utilisation

Memory Upgrade Module

Your notebook has two memory slots. If you have a module installed in only one slot, you can increase your memory
capacity by installing another memory module in the empty slot or by increasing the size of the single installed
module. In order to optimize the dual-channel design, modules of equal capacity should be used.
Your notebook supports dual-channel memory, which can have a great effect upon system performance. In order to
support dual-channel memory, two DIMM modules must be installed in your computer.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THOSE SPECIFICALLY SHOWN IN THE DIRECTIONS FOR
INSTALLING AND REMOVING THE UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
THE FOLLOWING
•
B
EFORE HANDLING A MEMORY MODULE
•
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS
•
P
OWER DOWN YOUR SYSTEM BEFORE YOU ADD OR REMOVE MEMORY MODULES
DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
•
T
HE INSTALLATION OF INCOMPATIBLE MEMORY MODULES CAN CAUSE NUMEROUS PROBLEMS WHICH COULD RESULT IN LOSS OF DATA
HIGHLY RECOMMENDS THAT YOU ONLY PURCHASE ADDITIONAL MEMORY FROM THE
.
WWW SHOPFUJITSU
•
N
EVER RUN YOUR
MEMORY MODULES

Installing a Memory Module

Turn off power to your LIFEBOOK notebook and remove any power adapter.
1
Make sure that all connector covers are closed.
2
Turn the LIFEBOOK notebook bottom side up, with the front panel toward you.
3
Remove the memory upgrade module compartment by pressing the latch and lifting the cover. (Figure 36)
4
Remove the memory upgrade module from the static guarded sleeve.
5
:
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY
. .
COM
LIFEBOOK
WITH THE MEMORY UPGRADE COMPARTMENT COVER INSTALLED
.
64 - Memory Upgrade Module
.
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
. E
F
UJITSU ON
(ESD). T
O MINIMIZE RISK TO THE MODULE
VEN IF THE SYSTEM IS IN HIBERNATE OR
.
-
LINE ACCESSORY STORE AT
. D
OING SO COULD RESULT IN DAMAGE TO THE
,
OBSERVE
.
. D
O NOT TOUCH
.
S ,
LEEP STATES
. F
UJITSU
: