Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LIFEBOOK AH752 Mode D'emploi

Removing a Memory Upgrade Module

1
Perform steps 1 through 4 of Installing a Memory Upgrade
Module.
2
Pull the clips sideways away from each side of the memory
upgrade module at the same time.
3
While holding the clips out, remove the module from the slot by
lifting it up and pulling it away from your notebook.
4
Store the memory upgrade module in a static guarded sleeve.
5
Replace the cover and reinstall the screws.

Checking the Memory Capacity

Once you have changed the system memory capacity by
replacing the installed module with a larger one, be sure to
check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] -> Control
Panel -> System and Maintenance -> System. The amount
of memory is displayed next to "Memory - RAM:"
There may be a variation between the actual memory size and what is displayed. This is possible if your
system is configured with an integrated Intel Graphics Media Accelerator which dynamically allocates
system memory to accelerate graphics performance.
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED
CORRECTLY RECOGNIZED
. (I
F THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
, T
SEE ROUBLESHOOTING ON PAGE
66 - Memory Upgrade Module
Figure 27. Removing memory module
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS
71.