Pioneer DVD-D7563 Mode D'emploi page 9

1. When inserting a drive, be sure to
place the drive on the changer guide
rails and push the drive in until the
lock lever on the drive shifts to the
locked position. Maybe you can hear
a clicking sound then.
Drive
Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
2. Connect the power cable.
When the power cable has been
connected, the wiring monitor indicator
on the rear of the drives (orange) will light
up.
When the termination switch of the drive
is set to on, the termination indicator
(green) will light up.
Power cable
Wiring monitor
indicator
Termination indicator
3. Connect the changer interface cable.
When the changer interface cable has
been connected, the wiring monitor
indicators will flash at two-second
intervals.
Guide rails
NOTE:
Connect the changer interface cable to the
connector corresponding to the bay in which the
drives have been installed. (Note that labels are
affixed to connectors indicating the corresponding
bay number.) Note that it is extremely important
to do this, as connecting the changer interface
cable to a neighboring bay will result in damage to
discs and the disc transport mechanism.
4. Connect SCSI cables.
The way in which SCSI cables should be
connected differs depending on how the
changer is to be configured. For further
information on how to connect SCSI cables,
see the operating instructions for the DRM-
7000 disc changer.
NOTES:
If the changer interface cable has not been
properly connected, the changer will not be able
to recognize the drive at all. You should check
the wiring monitor indicator located on the back
of the drive. When the cables have been
properly connected, the indicator ought to be
flashing.
If the indicator is lit, check to make sure that
the changer interface cable of the drive in
question has been properly connected.
If the indicator is not lit, check to make sure
that the power cable of the drive in question
has been properly connected. If the cables
need to be reconnected, reconnect the power
cable before reconnecting the changer
interface cable.
If the drive is recognized but the model name
of the drive is not displayed in the lower half of
the LCD message window, disconnect all three
cables and reconnect them again.
Order in which cables are to be disconnected:
1. SCSI interface cable
2. Changer interface cable
3. Power cable
Order in which cables are to be reconnected:
1. Power cable
2. Changer interface cable
3. SCSI interface cable
TO INSTALL THE DRIVE
Wiring monitor
indicator
Changer interface cable
9
En