Pioneer DVD-D7563 Mode D'emploi page 7

A HARDWARE TOUR
REAR VIEW
8
1 SCSI termination switch
This switch is used to turn the drive's
internal SCSI termination switch on and off.
Note that this switch is set on at the time of
shipment.
2 Data block size switch
This switch is used to set the data block size.
When this switch is turned on the data block
size is set to a length of 2048 bytes, and
when it is set off the data block size is set
to a length of 512 bytes.
Note that this switch is set on at the time of
shipment.
3 Termination indicator
When the drive is installed in a changer and
its power cable has been connected, this
indicator lights up if the drive's SCSI
termination switch has been turned on.
4 Wiring monitor indicator
Meaning of indicator when indicator is
lit up:
This indicator also lights up when the
drive is installed in a changer and its
power cable has been connected.
Meaning of indicator when indicator
flashes in 2-second intervals:
This indicator flashes in 2-second
intervals when the drive is installed in a
changer and its changer interface cable
has been connected.
Meaning of indicator when indicator
flashes in 0.5-second intervals:
This indicator flashes in 0.5-second
intervals when the drive in question has
1 2 34 5
WIRING MONITOR IND
ON
SCSI TERM IND
BLOCK SIZE
TERM ON / OFF
SCSI ID
6
BLOCK SIZE
OFF 512 byte
ON 2048 byte
9
been specified as the drive to be
swapped during the swapping of drives.
5 Changer interface cable
This cable must be connected to the
c h a n g e r- i n t e r n a l c h a n g e r i n t e r f a c e
connector.
6 Power cable
This cable must be connected to the power
inlet located in the changer.
7 Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
8 SCSI ID switches
These switches are used to set the drive's
SCSI ID. Pressing the upper switch causes
the displayed SCSI ID to be decremented,
and pressing the lower switch conversely
causes the SCSI ID to be incremented. Note
that SCSI ID is set to '0' at the time of
shipment.
9 SCSI interface connector
This connector must be connected to the
SCSI cable provided with the changer or to
an add-on SCSI cable.
NOTE:
Be careful not to allow any part of your body to
come into contact with connector pins, as doing
so may result in faulty connections or damage from
static electricity.
7
RELEASE LOCK
7
En